Queen bunk bed with desk – A computer table created under a bunk bed loft makes for a pleasant working space for your child. This space defined for homework can help your child focus during study time, while saving nearly 30 square meters. This whole project should take about three to four hours. These instructions are too add computer desk below the bunk bed.
First steps to queen bunk bed with desk is form a rectangle with two beams of 39 inches and 24 inches two beams. Mounting and connecting the rectangle as you did for the bed frame. Lay, 39-inch sheet of plywood 24 inches at the top of the frame and screw in place as it did with the bed frame. Establish a 30 – inch set in the corner of the plot, set in the angle formed by two beams.
Screw the pole in place with four wood screws located in a square. Drill through the plywood and end of the post. Screws deep enough the head does not stick in any job. Repeat steps three and four for the other three posts. Use the drill bit to drill a hole 1 1/2 inches in diameter in the center of one long side of the table, place 1 1/2 inches from the edge. Use this hole for the cables when installing your computer. You’re queen bunk bed with desk was ready to use.